Pump tube PP for mixing and pumping

for low viscosity acids

Order number: 0110-355
Price: upon request
not suitable for flammable liquids

Description: The Lutz Pump tube (PP) is suitable for corrosive, aqueous to slightly...more

Close menu

Product information "Pump tube PP for mixing and pumping"

Immersion depth: 1000 mm
Type of seal: sealless (DL)

Description:

The Lutz Pump tube (PP) is suitable for corrosive, aqueous to slightly viscous media. Depending on the application, various Motors are available which you can combine with the Pump tube at any time. This means you are flexible at all times and thus save important resources.

also available in special immersion depths from 200 - 2500 mm
Pump tube equipped with Lutz original handwheel
Suitable for mixing and pumping oils such as rapeseed oil and vegetable oil

Features & Advantages

Optionally with electric or compressed air drive
No lubricants and therefore no contamination of the pumped medium by lubricants
Two functions (pumping and mixing) in one unit
No leakage in case of inclined position or moving of the pumping unit
High mixing and conveying capacity for thorough homogenization
Switching between the pumping and mixing functions takes place without disturbing the ongoing operation, which is made possible by a small lever on the handwheel

Technical data

Pump tube (material):

PP (polypropylene)

Impeller (material):

PP (polypropylene)

Static seal (material):

no seals in contact with the medium

Bearing (material):

ETFE / PTFE

Drive shaft (material):

Hastelloy C (2.4610)

Delivery rate (up to max. l/min)*:

Delivery head (up to max. mWS)*:

Fluid temperature (max °C):

density (up to kg/dm³):

1.9

Viscosity (up to mPas):

800

Conveyor wheel shape / drive type:

Radial-flow impeller

Seal type:

Sealless (SL)

Immersion length (mm):

from 1000 mm

Immersion tube diameter (up to mm):

Thread (inch) outside:

1 1/4"

Type:

MP PP 50/41-L DL HC

* The maximum flow rate is a value determined by means of a test bench and measured with water at a medium temperature of approx. 20 °C. The measurement is carried out at the pressure joint of the pump, without hose, nozzle or flow meter. The achievable flow rate in use is lower and depends on the individual application, the liquid properties and the configuration of the pump. The max. delivery head also depends on the pump design, motor and fluid. The viscosity values are determined with oil.

** Test assembly: Medium water / diesel, flow in preferred direction, settling section 0.2 m upstream and downstream of flow meter

Stainless steel shaft

Impeller

Pump tube PP for mixing and pumping

for low viscosity lyes